Search results

Page title matches

• Brake fluid
  ...uper DOT 4) brake fluid, changed annually. This is a fully synthetic brake fluid that exceeds the boiling point specifications of most DOT 5.1 fluids and is ...oils.co.uk/p-742-castrol-react-performance-dot-4-fully-synthetic-car-brake-fluid.aspx]
  6 KB (1,037 words) - 20:04, 9 May 2016
• Brake Fluid Explained
  Brake fluid... Bit of a mystery topic! There is a degree of confusion regarding the specification of brake fluid and this article sets out to clarify the situation.
  4 KB (618 words) - 11:50, 11 June 2022

Page text matches

• Brake fade
  ...iately replaced as its ability to resist boiling has been greatly reduced. Fluid testing should be regularly done as a matter of course. It should be replac Always use the highest-grade fluid possible.
  1 KB (237 words) - 17:09, 8 June 2007
• Brake Fluid Explained
  Brake fluid... Bit of a mystery topic! There is a degree of confusion regarding the specification of brake fluid and this article sets out to clarify the situation.
  4 KB (618 words) - 11:50, 11 June 2022
• Examples of a broken damper
  ...on an Elise. Most common failure is a 'leaking' damper where the hydrolic fluid leaks from the damper assembly.
  318 bytes (54 words) - 14:59, 20 June 2009
• Replace the coolant
  [[Category:Fluid]]
  505 bytes (77 words) - 11:18, 25 February 2008
• Replacing S1 front near-side brake pipe
  ...at if system still has brake fluid in it then be prepared to catch leaking fluid)
  1 KB (197 words) - 19:43, 4 July 2014
• Brake fluid
  ...uper DOT 4) brake fluid, changed annually. This is a fully synthetic brake fluid that exceeds the boiling point specifications of most DOT 5.1 fluids and is ...oils.co.uk/p-742-castrol-react-performance-dot-4-fully-synthetic-car-brake-fluid.aspx]
  6 KB (1,037 words) - 20:04, 9 May 2016
• S1 Brake Light Switch
  ...nt services compartment (bonnet if you like), look behind the brake/clutch fluid reservoir and you will see a small black box with 2 wire coming from it. It
  1 KB (270 words) - 20:33, 18 October 2007
• Replacing S1 rear brake pipes
  ...at if system still has brake fluid in it then be prepared to catch leaking fluid)
  2 KB (329 words) - 21:07, 20 February 2019
• How to Fit A Spray Bar
  7.)Empty washer bottle of fluid
  2 KB (309 words) - 13:17, 20 February 2011
• Bleed the brakes
  If it's just for flushing the system with new fluid (no air in the system) then it's pretty straightforward and you don't have If no bubbles are in the system and you just want to refresh the brake fluid, you can either connect a pressure bleeder or bleed manually.
  7 KB (1,292 words) - 13:27, 11 June 2022
• Thermostat
  ...isn't very good then it will tend to overshoot and hence the glugs of cold fluid coming through will give your engine a good thermal shock test which induce
  2 KB (340 words) - 08:54, 3 August 2007
• Brake hoses
  '''Brake hoses''' are used to transfer [[brake fluid]] to the [http://en.wikipedia.org/wiki/Disc_brake brake calliper] and force
  2 KB (352 words) - 12:13, 30 May 2013
• Petrol
  Today, ‘petrol’ is really a synthetic fluid built up from oil industry feedstocks. Very little of it is unmodified dist [[Category:Fluid]]
  5 KB (840 words) - 13:20, 8 July 2009
• Brakepad, rear change
  ...the cap from the fluid reservoir and use a turkey baster to suck out some fluid. Screw in the caliper/check level/remove fluid if needed /screw in some more/repeat if in doubt
  5 KB (861 words) - 21:23, 18 January 2019
• Toe alignment using straight edges
  # Four 5 liter sprinkler fluid bottles ...inkler fluid bottles are ideal as they are suitably heavy when filled with fluid, they are level on top and their height conveniently matches the center hei
  5 KB (924 words) - 21:26, 19 April 2020
• S2 interior plastics refurb
  I tried using isopropyl alcohol, lighter fluid, magic erasers, 800 grit sandpaper and grey Scotchbrite pads. ...ner. Scrubbing the rubber off in layers after a liberal soaking of lighter fluid worked well. It did take a very long time, with elbow grease and patience r
  3 KB (600 words) - 16:25, 26 May 2020
• S2 Track Modifications
  ===2. Brake Pads and Fluid=== ...fresh fluid (Castrol Super DOT4 £10, AP600 £20, SRF £50) and plan to bleed fluid regularly (every 2 to 6 track hours) plus completely change it annually (Lo
  11 KB (1,955 words) - 21:22, 28 February 2008
• Downforce
  ...d the basic rules of [http://en.wikipedia.org/wiki/Bernoulli%27s_principle fluid dynamics], for a given volume of air, the higher the speed the air molecule
  3 KB (618 words) - 10:52, 2 March 2007
• Oil filters for Honda conversion
  [[Category:Fluid]]
  1 KB (232 words) - 08:50, 24 August 2018
• Change a front wheel bearing
  ...Allen key<br />Torque wrench<br />Bearing circlip pliers<br />Penetrating fluid<br />Hydraulic press (at least 10 tonne)<br />Duralac<br />Threadlock or Pi Spray the bearing and inner hub carrier thoroughly with penetrating fluid and leave a few minutes to soak.
  9 KB (1,548 words) - 17:51, 17 October 2022

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)