Search results

[[Image:carpet1.jpg|thumb|left|put a short description here]] [[Image:carpet2.jpg|thumb|left|put a short description here]]

...able pedal. Once the 2 minutes have passed, release the pedal and go for a short drive, using the brakes as normal to let everything return to normal temper

...e obviously not intended for a mid engine car as they turned out to be too short. I had to cut them and solder in another 50 cm of cable. From the sensors t ...late had to be created. I decided to remove the two right hand screws that hold the heater panel in place and drill two new holes on the other side of the

...handle as well as you'd think - in my view I suspect the wheel base is too short for the power and the engine is almost rear mounted rather than mid so it's ...ise like (no surprises there) but where it really shines is under braking. Short of hitting a large immovable object or fitting a parachute and chucking an

...up current is a lot higher as the high voltage needs to be generated for a short while. This causes the 10 Amp fuse to blow (it's actually very close to 10 ...ight up, but as the ballast only draws this ''rush in current'' for a very short period, the wires will cause a resistance in the system. Extra resistance s

...rger allen key, or similar size 'bar' for extra leverage in the grub screw hold, turn the knob '''anti-clockwise''' (as looking from the top). I used a short length of old mountain bike inner tube folded back on itself for double thi

...th a 15mm (K Series) socket/spanner and drain oil into something that will hold 5 litres of fluid. # Start the engine, check it fires and run for a short while.

#Cut a short 3" piece of wire to join the 30 and 85 pins on the relay to the "main" 12v ##Put a female blade connector on the end of a short (3-4") piece of wire - connect this to pin 30 on the relay.

...he fore of the engine mount will require a socket, a universal joint and a short extension bar.

2) Hold down both buttons (remote fob LED will light), holding down for approx.10 s #If the PIN is entered correctly, the alarm will sound a short beep and will now be overridden and the engine mobilised.<br>However passiv

**Disconnect the single stack connector – there is a latch that you need to hold down and it’s quite stiff **Two small bolts hold the 5AS unit onto the main steering column bracket. It is possible to remo