Editing Vehicle security system (section)

====Programming Additional Transmitters====

A max of 6 transmitters may be programmed to the car, any thereafter overwriting the first to have been programmed.

#With the engine immobilised (tell tale flashes briefly once per second), turn on the ignition
#Enter the PIN as detailed above, followed by the additional two digits 1, 1.
#The tell tale will flash rapidly for one second, then turn off.
#Within 8 seconds, press any button on the transmitter to be programmed.<br>The tell tale will then pulse rapidly and the siren will beep
#Within 10 seconds, press any button on the next transmitter to be programmed (if applicable) and repeat this process for all remaining transmitters.
#When all transmitters have been programmed, wait for 10 seconds , of turn off the ignition.

To disable a lost or stolen transmitter from the system, use the above procedure to programme 6 transmitters, if necessary, repeatedly reprogramming the same transmitter if less than 6 programmed transmitters are to be used.


pfk manual elise s2 alarm http://www.warp.at/liz/pfk457/D457520RV3.pdf

WORKS ON 2005 CAR

REMOTE KEY FOB - PROGRAMMING - USE WHEN ADDING A NEW REMOTE INTO THE SYSTEM

IGNITION MUST BE ON AND THE ALARM OFF

STEP 1 – PREPARING ALL REMOTE KEY FOBS - ALL FOBS MUST BE DONE SIMULTANEOUSLY

Press and hold both buttons on remote until the LED stops flashing (about 10 seconds).

Do this for all remotes to be programmed 

The LED on the remote should stay on until after programming. 

If the LED on the remote extinguishes by the time you want to program, the key has gone into battery
saving mode, press large button once to bring the LED back on then proceed with programming.

STEP 2 – ENTER PIN 

1) Turn ignition ON and OFF 3 times within 5 seconds.

2) Security LED will blink once indicating that the security code can now be entered.

3) Enter security code as follows:

.... a) Turn ignition ON & count number of blinks representing 1ST digit of code then turn ignition OFF.

.... b) Repeat for 2nd digit.

.... c) Repeat for 3rd digit.

.... d) Repeat for 4th digit.

4) Turn ignition ON and LED will come on permanently if correct code has been entered

STEP 3 – COMPLETE THE REMOTE KEY FOB PROCEDURE 

1) Press and hold the large button on one of the remotes until the security LED light in the tachometer goes out then comes back on.

2) Do this for each remaining remote

3) Turn off the ignition and check each remote for the correct operation.





[[Category:Electrical]]
[[Category:Lotus Elise]]
[[Category:Lotus Exige]]
[[Category:S2 Exige]]
[[Category:S1]]
[[Category:S2]]