Editing Fit a HID kit (section)

==TUTORIAL: Fitting of £60 HID kit by steve1978.==

[[http://thumbnails17.imagebam.com/4540/8ee86b45397141.gif]] [[http://thumbnails8.imagebam.com/4540/4adb0045397145.gif]]

Kit consists of:
2 ballasts
2 Bulbs
all connections
nuts and bolts
cable ties.

Other kit required.
trolley jack
flat head screw driver 
cross head screw driver
electricians tape.

Time taken approx 30 mins per light.

Step1: Remove the wheel 

Step 2: Remove the 3 flat headed larger thumb screws. Now the light lense will come off

Step 3: Back under the wheel remove the screws holding the wheel arch lining in place. when complete ease the lining out

Step 4: On the top of the liner there is a void. this is where the ballast will be fitted (between the body and the lining), if you look through the bonnet vent you may just be able to see the location of the ballast.

Step 5: Remove the existing light bulb and insert your new one, you may find it easier to remove the lighting unit, we did (3 cross headed screws on the inside of the arch). feed the cables through the hole and connect them up. there is only one possible way to connect them.

Step 6: Insert the liner back in to the wheel arch and connect the lights back to the ballast, now test the lights. if all is working then reassemble

Step 7 Stand back and be proud!

[[http://17.imagebam.com/dl.php?ID=45397141&sec=7658bdc643c587d162bb668fe80a12ff]]

[[http://forums.seloc.org/viewthread.php?tid=232203&page=1]]