Editing Evora DIY Sill Wrapping (section)

==Cutting the vinyl==

My favourite bit - pulling the wire through the vinyl to cut it to shape - very satisfying..

[[image:Evora-DIY-Sill-Wrapping-16.jpg|400px]]

Peel away the surplus vinyl

[[image:Evora-DIY-Sill-Wrapping-17.jpg|400px]]

Remove / peel out traces of the cutting tape - then apply a little heat to seal the top edge - press down firmly.

[[image:Evora-DIY-Sill-Wrapping-18.jpg|400px]]

Cut the vinyl away from the leading edge of the sill - giving you a little to wrap around the front edge of the sill gap

[[image:Evora-DIY-Sill-Wrapping-19.jpg|400px]]

Apply a bit of heat and tuck in

[[image:Evora-DIY-Sill-Wrapping-20.jpg|400px]]

Underneath - simply run a knife gently along the sill between the under tray and the sill - to trim off excess overlapping film.

Apply cutting tape to the A-Post - keeping the tape in line with the previous vinyl edge - then simply take your off cut from the end of the strip and apply - tucking / folding the front edge behind the mudflap.

[[image:Evora-DIY-Sill-Wrapping-21.jpg|400px]]