Editing Fit a PRRT (section)

===Modifying the Kit===

This part is the most important of all: cutting the Kit hoses to make it fit. I prefer not to give measures about where you should cut the hoses because, on another car, the lengths required could be slightly different. you can take the photos as a guideline, but BE CAREFUL as, once you cut a hose too short, you are into trouble. My advice is to leave 2 cm extra hose as a safety margin, use no clips and then cut again where needed after having tried to make it fit. To achieve a clean rubber cut, you can insert the remaining of the aluminium tube where you need to do the cut. Hoses H and D need no cutting.

*Once reassembled, the PCH001190 kit should look like this:
[[Image:EliseKit.jpg|thumb|left|Click to Enlarge]]
{{clr}}

*Here below is the kit and the two parts it is going to replace:
[[Image:compare.jpg|thumb|left|Click to Enlarge]]
{{clr}}