Editing Cambelt (section)

===Waterpump Change===

21 If you intend to change the waterpump as well (and if you're in here already its probably worth it !!), now is the time to do it. Drain the coolant by undoing and hoses that enter both side rails at the rear of the car

22. Unbolt the old pump and remove it. (Expect more coolant to flow from the engine block). There are 6 bolts circled in the photo. The top left is bolted from the rear side, the bottom right is a pillar bolt (used for the front cover as well) and there are two dowels, squared in the photo. Check that the old rubber sealant ring was removed with the old pump and if there is any corrosion around the face/dowels remove with wet an dry paper. The block surface should be clean to allow the new pump to fit well 

[[File:Waterpump Bolts.JPG|thumb|none|Waterpump Bolts and Dowels]] 

23. Ensuring the new sealant ring is in place in the groove on the new pump and fit the pump (you can use some (proper) automotive RTV silicon to hold the new sealant ring in place if required). Tighten the bolts in stages alternating between diagonally opposite bolts to 10Nm