Editing Idle Air Control Valve (section)

==S2==
Removal, cleaning and refitting is a 20 minute job. Unplug the loom attachment first. The valve assembly is held in place by four torx screws. The lower two are not visible and have to be located by feel. When the assembly comes free be careful not to drop the rubber seal. Detach the hose. Cleaned with copious amounts of carburettor cleaner spray (until the fluid runs clear). Fitting is reverse of removal, use silicon grease on the seal before reseating. Screw torque 1.5nm.

http://forums.seloc.org/viewthread.php?tid=166362&page=1#pid3289867

===Location===
[[Image:iacv_in_situ.jpg|thumb|left|Idle Air Control Valve (S2 K-Series) In Situ]]
{{clr}}
[[Image:iacv_released.jpg|thumb|left|Idle Air Control Valve (S2 K-Series) Released]]
{{clr}}