Editing Footwell Corrosion (section)

===Filling===

Remove the remains of the double sided tape from around the edge of the floor. I used a hot air gun, glue remover (solvent) and a razor blade scraper.

I made sure the floor pan was completely dry by leaving a small heater under the floor pan, this is important because you don't want to trap any moisture.

The pitting was then filled with some chemical metal which is just an epoxy type glue available from most DIY shops. I did this by scraping it in with a Stanley knife blade to leave a nice level finish. There was only 2 very small holes so I stuck some tape to the underside which stopped the glue from going all the way through, it can hardly be seen from the underneath.

[[Image:M111 - Footwell Treatment - Step 3.jpg|thumb|center|400px]]