Editing Pedal Box Refurbishment (section)

=====If You're using the standard Lotus arangement=====


*Fitting the pedals
**Taking car to ensure that the shaft is inserted the correct way around, slide it into the pedal box to the brake pedal aperture.
**Fit a thrust washer, then the bushed pedal, then the second thrust washer into the aperture.
**Repeat step the above for the clutch pedal.

*Fully screw the shaft into position, taking care to ensure that the thrust washers are properly seated on the small machined shoulder of each pedal aperture.

*Fit the throttle pedal pivot bearing with flange to the left when looking at the front of the pedal

*Fit a thrust washer then the bushed throttle pedal, then the second pivot bearing spacer (oriented with flange adjacent to pedal) with a dab of LM grease between each component to ensure that they don’t fall off during reassembly.