Window adjustment - Revision history

R Dawn: /* S2 Window Adjustment */

2018-11-12T11:05:01Z

S2 Window Adjustment

← Older revision		Revision as of 11:05, 12 November 2018
Line 40:		Line 40:
	To adjust the stop, use a 10 mm spanner to release the lock nut. This is best done with the window fully up as the stop will be held tight by the window mechanism.		To adjust the stop, use a 10 mm spanner to release the lock nut. This is best done with the window fully up as the stop will be held tight by the window mechanism.
	Once the lock nut is released, wind the window down a little and using fingers, screw the stop in or out as required. Once correctly adjusted, nip up the lock nut.		Once the lock nut is released, wind the window down a little and using fingers, screw the stop in or out as required. Once correctly adjusted, nip up the lock nut.

			More adjustments can be made on electric window variants, see website of Sand's Mechanical Museum: http://www.sandsmuseum.com/cars/elise/experience/maintenance/windowfix/windowfix.html

	[[Category:Interior]]		[[Category:Interior]]

Paulf1965: /* WARNING - TURNING THE S2 REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!! */

2013-02-05T20:36:33Z

WARNING - TURNING THE S2 REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!!

← Older revision		Revision as of 20:36, 5 February 2013
Line 1:		Line 1:

	== WARNING - TURNING THE S2 REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!! ==		== WARNING - TURNING THE S2 REAR ADJUSTER IN TOO FAR CAN CRACK THE DOOR SKIN!!! ==

Paulf1965: /* WARNING - TURNING THE REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!! */

2013-02-05T20:35:57Z

WARNING - TURNING THE REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!!

← Older revision		Revision as of 20:35, 5 February 2013
Line 1:		Line 1:

	== WARNING - TURNING THE REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!! ==		== WARNING - TURNING THE S2 REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!! ==

Paulf1965 at 20:35, 5 February 2013

2013-02-05T20:35:23Z

← Older revision		Revision as of 20:35, 5 February 2013
Line 1:		Line 1:

			== WARNING - TURNING THE REAR ADJUSTER TOO FAR CAN CRACK THE DOOR SKIN!!! ==


	===S1 Window Adjustment===		===S1 Window Adjustment===

Tyrex at 20:21, 5 February 2013

2013-02-05T20:21:52Z

← Older revision		Revision as of 20:21, 5 February 2013
Line 14:		Line 14:

	In the picture above the red arrows indicate the adjusters for window tilt towards/away from the roof. They adjust the bottom of the window runners inwards/outwards, thus causing the top of the window to adjust out/in from the roof. These can be adjusted without removing the door card. Clockwise turns press the window tighter against the seal when up.		In the picture above the red arrows indicate the adjusters for window tilt towards/away from the roof. They adjust the bottom of the window runners inwards/outwards, thus causing the top of the window to adjust out/in from the roof. These can be adjusted without removing the door card. Clockwise turns press the window tighter against the seal when up.

			Important note: take great care not to over-tighten this screw as there are a number of examples of owners finding the screw has pushed through the door skin and caused cracking on the outside paintwork!
	<br><br><br>		<br><br><br>
	If you want to adjust the height of the window at the front/back of the window then the door card must be removed. Undo the fasteners indicated by the green arrows in the above picture. The lower mid and rear sections of the card are held on by velcro, and just pull away after the other fasteners are removed. Replace the window winder, as you'll probably need to move the window up and down whilst adjusting.		If you want to adjust the height of the window at the front/back of the window then the door card must be removed. Undo the fasteners indicated by the green arrows in the above picture. The lower mid and rear sections of the card are held on by velcro, and just pull away after the other fasteners are removed. Replace the window winder, as you'll probably need to move the window up and down whilst adjusting.

VinZ667: /* S2 Window Adjustment */ add adjustment screw rotation direction

2012-12-09T09:09:23Z

S2 Window Adjustment: add adjustment screw rotation direction

← Older revision		Revision as of 09:09, 9 December 2012
Line 13:		Line 13:
	[[image:Door card.jpg]]		[[image:Door card.jpg]]

	In the picture above the red arrows indicate the adjusters for window tilt towards/away from the roof. They adjust the bottom of the window runners inwards/outwards, thus causing the top of the window to adjust out/in from the roof. These can be adjusted without removing the door card.		In the picture above the red arrows indicate the adjusters for window tilt towards/away from the roof. They adjust the bottom of the window runners inwards/outwards, thus causing the top of the window to adjust out/in from the roof. These can be adjusted without removing the door card. Clockwise turns press the window tighter against the seal when up.
			<br><br><br>
	If you want to adjust the height of the window at the front/back of the window then the door card must be removed. Undo the fasteners indicated by the green arrows in the above picture. The lower mid and rear sections of the card are held on by velcro, and just pull away after the other fasteners are removed. Replace the window winder, as you'll probably need to move the window up and down whilst adjusting.		If you want to adjust the height of the window at the front/back of the window then the door card must be removed. Undo the fasteners indicated by the green arrows in the above picture. The lower mid and rear sections of the card are held on by velcro, and just pull away after the other fasteners are removed. Replace the window winder, as you'll probably need to move the window up and down whilst adjusting.

Pum at 18:58, 6 November 2010

2010-11-06T18:58:37Z

← Older revision		Revision as of 18:58, 6 November 2010
Line 7:		Line 7:
	The S2 windows can need adjusting now and then.		The S2 windows can need adjusting now and then.

	First of all ensure the softtop is fitted correctly.		First of all ensure the softtop or hardtop is fitted correctly.

			The following pictures and details are for a 2001 Elise - may be different for more recent or US models.

	[[image:~~windowscrews~~.jpg]]		[[image:Door card.jpg]]

	On the picture above		In the picture above the red arrows indicate the adjusters for window tilt towards/away from the roof. They adjust the bottom of the window runners inwards/outwards, thus causing the top of the window to adjust out/in from the roof. These can be adjusted without removing the door card.

			If you want to adjust the height of the window at the front/back of the window then the door card must be removed. Undo the fasteners indicated by the green arrows in the above picture. The lower mid and rear sections of the card are held on by velcro, and just pull away after the other fasteners are removed. Replace the window winder, as you'll probably need to move the window up and down whilst adjusting.

			[[image:Door Inner.jpg]]

			In the picture above the blue arrows indicate the adjusters for window height and tilt. Loosen them both a little with an 8mm socket, and move them up and down to adjust height and tilt of the window.

			There is apparently an adjuster at the position marked by the orange arrow to move the window forwards/backwards, but I am unable to locate it on my car. Perhaps the upper trim needs to be removed.

	~~'''1''' and '''4''' will adjust window tilt.~~

	~~'''2''' and '''3''' will adjust window height, you will need to remove the window winder and door cover.~~

	~~'''5''' will adjust window back and forth.~~
	[[image:door.JPG\|thumb\|none\|Inside of a 06' Elise door]]		[[image:door.JPG\|thumb\|none\|Inside of a 06' Elise door]]

Mr Wiki at 09:46, 16 November 2009

2009-11-16T09:46:04Z

← Older revision		Revision as of 09:46, 16 November 2009
Line 3:		Line 3:
	[[image:s1windowadj.JPG\|left\|S1 Window]]		[[image:s1windowadj.JPG\|left\|S1 Window]]
	{{clr}}		{{clr}}



	===S2 Window Adjustment===		===S2 Window Adjustment===

Mr Wiki at 09:45, 16 November 2009

2009-11-16T09:45:53Z

← Older revision		Revision as of 09:45, 16 November 2009
Line 1:		Line 1:
	===S1 Window Adjustment===		===S1 Window Adjustment===

	[[image:s1windowadj.JPG~~\|thumb~~\|left\|S1 Window]]		[[image:s1windowadj.JPG\|left\|S1 Window]]
	{{clr}}		{{clr}}

Mr Wiki at 09:45, 16 November 2009

2009-11-16T09:45:34Z

← Older revision		Revision as of 09:45, 16 November 2009
Line 2:		Line 2:

	[[image:s1windowadj.JPG\|thumb\|left\|S1 Window]]		[[image:s1windowadj.JPG\|thumb\|left\|S1 Window]]
			{{clr}}