Difference between revisions of "Window Problems"
m |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Problem encountered with an S2 drivers side window sticking 2" open. | + | *Problem encountered with an S2 drivers side window sticking 2" open.* |
Even with door card off and the door handle mech out to have a good look, its pretty difficult to gain access to the window. | Even with door card off and the door handle mech out to have a good look, its pretty difficult to gain access to the window. | ||
| Line 13: | Line 13: | ||
Just fixed the same issue with the passenger side, this time the double headed adjusting screw at the bottom of the window guide had come loose from the window guide and this allowed the nylon slides to come free of the window guide, the nylon slides have a u shaped back to attach over the window guide, fixed by manipulating the slides back over the window guides and screwing the double headed adjuster into the bottom of the window guide. | Just fixed the same issue with the passenger side, this time the double headed adjusting screw at the bottom of the window guide had come loose from the window guide and this allowed the nylon slides to come free of the window guide, the nylon slides have a u shaped back to attach over the window guide, fixed by manipulating the slides back over the window guides and screwing the double headed adjuster into the bottom of the window guide. | ||
| + | |||
| + | *Elise S2 manual window jammed halfway up (i.e. would not close) | ||
| + | |||
| + | This was caused by a bolt in the steel door bar working loose (I had a light jingling from the door for a few months) | ||
| + | The bolt then eventually worked far enough out to catch the white plastic guide blocks and prevent the window winding up; | ||
| + | |||
| + | https://gallery.seloc.tv/albums/userpics/40285/91990457-2719-4BDE-8F31-489F5EF785BD.jpeg | ||
| + | |||
| + | https://gallery.seloc.tv/albums/userpics/40285/C3753F64-CD15-4FED-8F92-E47D9D82C981.jpeg | ||
| + | |||
| + | 1) take the winder off | ||
| + | |||
| + | 2) take the door panel off (4 bolts you can see on top, one plastic plug thing on the bottom corner near the hinge, the bottom of the panel is Velcro | ||
| + | |||
| + | 3) peel the plastic membrane off (try not to tear it) | ||
| + | |||
| + | 4) persuade the window to wind up fully (get the guide block past the bolt that’s loose | ||
| + | |||
| + | 5) you can then get a 13mm spanner on it and tighten the bolt | ||
| + | |||
| + | |||
| + | I found a torch (well bike light) in the bottom of the door shining up to be very useful. | ||
Latest revision as of 18:09, 22 August 2021
- Problem encountered with an S2 drivers side window sticking 2" open.*
Even with door card off and the door handle mech out to have a good look, its pretty difficult to gain access to the window.
Issue identified with the screw holding the top of the window guide rail at hinge end of door. This can loosen and sit proud of the guide. This then catches on the top slide (white nylon material sikoflexed to the side of the window) on the front edge of the window. Prior to removal of door card etc, lower the window, take the window seals off the door (these slide off easily by hand) and inspect window guide for loose fitting screw (if screw is loose, window guide will rattle). A short-handled philips screwdriver to tighten the screw and it's as good as new.
All in all its a 5 minute job with the right diagnosis.
Just fixed the same issue with the passenger side, this time the double headed adjusting screw at the bottom of the window guide had come loose from the window guide and this allowed the nylon slides to come free of the window guide, the nylon slides have a u shaped back to attach over the window guide, fixed by manipulating the slides back over the window guides and screwing the double headed adjuster into the bottom of the window guide.
- Elise S2 manual window jammed halfway up (i.e. would not close)
This was caused by a bolt in the steel door bar working loose (I had a light jingling from the door for a few months) The bolt then eventually worked far enough out to catch the white plastic guide blocks and prevent the window winding up;
https://gallery.seloc.tv/albums/userpics/40285/91990457-2719-4BDE-8F31-489F5EF785BD.jpeg
https://gallery.seloc.tv/albums/userpics/40285/C3753F64-CD15-4FED-8F92-E47D9D82C981.jpeg
1) take the winder off
2) take the door panel off (4 bolts you can see on top, one plastic plug thing on the bottom corner near the hinge, the bottom of the panel is Velcro
3) peel the plastic membrane off (try not to tear it)
4) persuade the window to wind up fully (get the guide block past the bolt that’s loose
5) you can then get a 13mm spanner on it and tighten the bolt
I found a torch (well bike light) in the bottom of the door shining up to be very useful.