Torque settings

Torque settings

Working on your car means you have to torque parts up when you fit them. Using correct torque levels is very important. Bolts will be tensioned when torquing up.

Always use a torque wrench when installing parts on your car!

Too much tension means the bolt will be stressed too much and can ultimately break. Not enough tension means the bolt can either run loose or it can move around. This will damage the bolt and it's brackets. This can ultimately also lead to catastrophic failures.

Only use 8.8 grade bolts in suspension applications. (wishbones, dampers etc.) 10.9 grade or even worse 12.9 grade bolts are hardened.
The hardening process will improve the maximum possible load on the bolt, but it will also make the bolt relatively.
Within suspension parts, you would rather see bolts bend than sheer. 8.8 grade bolts have the tendacy to bend, any hardended bolts have the tendacy to sheer.

Below is a guideline to the torque levels used on Metric bolts.
Bolt grades are printed on the head of the bolt.

Bolt Size	8.8	10.9	12.9	A2-70 (Stainless)
6mm (M6)	9Nm	13Nm	14Nm	7Nm
8mm (M8)	23Nm	33Nm	40Nm	17Nm
10mm (M10)	45Nm	65Nm	70Nm	33Nm
12mm (M12)	80Nm	115Nm	125Nm	57Nm
14mm (M14)	125Nm	180Nm	195Nm	xx
16mm (M16)	195Nm	280Nm	290Nm	xx

Engine mount torque figures (K-Series)	Nm
RH engine mounting bracket to engine	145
RH engine mounting bracket to rubber mounting	85
RH engine rubber mounting to chassis	45
RH engine steady arm bolts	85
LH engine mounting bracket to rubber mounting	85
LH engine mounting bracket to engine	45
Lower steady arm bracket to sump	85
Lower steady arm bolts	85

Use Permabond A130(A912E7033V)on the sump end bolt on the lower steady arm