Difference between revisions of "Heater"

Latest revision as of 12:11, 11 December 2009

For S1 see Heater_Matrix The S2 Elise and Exige have two types of heater controls, manual or electrical. Cars after 2002?? have electrical.

The manual controls are prone to ceasure and the electrical controls prone to water ingress and failure.

Electrical controls

There are three elements to the heating in the Elise S2 with electrical controls.

Fan/Blower

By far the most common failure relating to the heating is corrosion of the resistor pack. Single, multiple or all fan speeds are lost. A guide exists to change the resistor pack yourself.

Flap distribution control

TBD??

Heater temperature control

For heater temperature control failure try the following fixes, which increase in complexity:

Remove air pipe and lube flap (See below)
Replace actuator through service panel (Only for small handed people!)
Heater Actuator Replacement after removing heater unit.

Remove the Access panels and black plastic covers.
Remove the air hose (no clips hold it its pressure fit).
Hose removed
Lubricate (The flap may be stuck in other positions)

DIY air filter

Modification to prevent grit from being sprayed onto the dash. You will need:

1 used stocking. 10 denier is best for optimum fan performance. Higher deniers can reduce air flow too much. Lace top optional.
Difficulty: Very, Very easy.

Directions:

Open the front service compartment
Remove one end of the air hose
Stretch stocking over air hose
Refit air hose.

Remember to replace or adjust the stocking annually, or when you notice a drop in airflow.

@@ Line 1: / Line 1: @@
-==Heater modification to prevent grit from being sprayed onto the dash==
+For S1 see [[Heater_Matrix]]  The S2 Elise and Exige have two types of heater controls, manual or electrical.  Cars after 2002?? have electrical.
-You will need:
+The manual controls are prone to ceasure and the electrical controls prone to water ingress and failure.
-used stocking. 10 denier is best for optimum fan performance. Higher deniers can reduce air flow too much. Lace top optional.
-Difficulty: Very, Very easy.
-Directions
-. Open the front service compartment
-. Remove air hose
+==Electrical controls==
+There are three elements to the heating in the Elise S2 with electrical controls.
-. Stretch stocking over air hose
+===Fan/Blower===
+By far the most common failure relating to the heating is corrosion of the resistor pack.  Single, multiple or all fan speeds are lost.  A guide exists to change the [[resistor pack]] yourself.
-. Refit air hose.
+===Flap distribution control===
+TBD??
-Remember to replace or adjust the stocking annually, or when you notice a drop in airflow.
+===Heater temperature control===
+For heater temperature control failure try the following fixes, which increase in complexity:
+# Remove air pipe and lube flap (See below)
+# Replace actuator through service panel (Only for small handed people!)
+# [[Heater Actuator Replacement]] after removing heater unit.
-==Heater==
+<gallery>
+Image:heater1.JPG|Remove the [[Access panel|Access panels]] and black plastic covers.
+Image:heater2.JPG|Remove the air hose (no clips hold it its pressure fit).
+Image:heater3.JPG|Hose removed
+Image:heater4.JPG|Lubricate (The flap may be stuck in other positions)
+Image:heater5.JPG|
+Image:heater6.JPG|
+Image:heater7.JPG|
+</gallery>
-'''INFORMATION ON THIS PAGE IS INCORRECT, AND STILL UNDERGOING WIKI'ING.'''
+== DIY air filter ==
+Modification to prevent grit from being sprayed onto the dash.  You will need:
+* 1 used stocking. 10 denier is best for optimum fan performance. Higher deniers can reduce air flow too much. Lace top optional.
+* Difficulty: Very, Very easy.
+Directions:
+# Open the front service compartment
+# Remove one end of the air hose
+# Stretch stocking over air hose
+# Refit air hose.
-Remove the [[Access panel|Access panels]] and black plastic covers.
+Remember to replace or adjust the stocking annually, or when you notice a drop in airflow.
-[[image:heater1.JPG|thumb|left|Removing the Access Panels and plastic covers]]
-{{clr}}
-Remove the air hose (no clips hold it its pressure fit).
-[[image:heater2.JPG|thumb|left|Removing the hose]]
-{{clr}}
-[[image:heater3.JPG|thumb|left|Hose removed]]
-{{clr}}
-Lubricate (The flap may be stuck in other positions)
-[[image:heater4.JPG|thumb|left|click to view]]
-{{clr}}
-[[image:heater5.JPG|thumb|left|click to view]]
-{{clr}}
-[[image:heater6.JPG|thumb|left|click to view]]
-{{clr}}
-[[image:heater7.JPG|thumb|left|click to view]]
-{{clr}}