Difference between revisions of "Change a CAT"
TitaniumDan (talk | contribs) m |
|||
Line 26: | Line 26: | ||
Job is a carrot, first time will take hours as the bolts are all ruted, second time is a doddle. | Job is a carrot, first time will take hours as the bolts are all ruted, second time is a doddle. | ||
While the cat is off press out the studs with a vice and a suitable socket, makes things easier next time. | While the cat is off press out the studs with a vice and a suitable socket, makes things easier next time. | ||
+ | |||
+ | Note that some grades of SS bolts may seize over time with the extreme temperatures; the only way to remove them is to apply pressure until they shear, then they will need to be renewed (removal will be necessary once a year for MOT if you are fitting a CRP). If fitting a CRP, normal steel bolts will be fine as the constant removal-refitting is enough to keep them from rusting up. |
Revision as of 08:05, 30 August 2006
1) Drive to independent specialist such as Sinclaire's of Romford 2) Pay them
It is that simple
Hopefully someone will add the DIY info here
Or:
1) Diffuser off (Rearmost part of the undertray)
2) Undo nuts from Cat.
3) Cut off those that won't move, swear profusely.
4) Wiggle the Cat, silencer and flexi until it all comes apart (If nessecary remove rubber mount from the flexi)
5) Offer up CRP and fit the new stainless steel bolts in place not forgetting the gaskets
6) Tighten the new stainless steel nuts progressively as your CRP may not be an exact fit
7) Find gaskets on the floor undo the bolts and refit corectly
8) Refit diffuser
Job is a carrot, first time will take hours as the bolts are all ruted, second time is a doddle. While the cat is off press out the studs with a vice and a suitable socket, makes things easier next time.
Note that some grades of SS bolts may seize over time with the extreme temperatures; the only way to remove them is to apply pressure until they shear, then they will need to be renewed (removal will be necessary once a year for MOT if you are fitting a CRP). If fitting a CRP, normal steel bolts will be fine as the constant removal-refitting is enough to keep them from rusting up.