Replace the exhaust silencer

Replacing the exhaust silencer on the Elise is relatevely simple. The hardest part is removing the three bolts securing the silencer to the CAT.

S1

Tools

  17mm ring spanner
  17mm socket and breaker bar
  13mm socket
  Torch
  Plusgas
  8mm socket and 4mm (?) allen key to remove the undertray

If you want to be really through you could buy the following parts (in stainless if you like) which replace the nuts and bolts that are probably very rusty.

2 x cat gasgets (Rover WCM 10480), 
6 x 10mm x 30mm hex bolts
12 x 10mm plain washers
6 x M6 full nuts
6 x M6 x 35mm hex bolts
6 x 6mm plain washers
6 x M6 full nuts
1 x Catalyst hanger bracket (Lotus part A111G6001F)

Back the car onto ramps

Remove the under-tray

Soak the Nuts at each end of the cat and the bolts fixing the exhaust hangers in PlusGas , WD40, or the like.

leave overnight

Often easier to unbolt the 17mm nuts on the inlet side of the cat as they tend to be less rusted, the cat and siliencer can bet seperated more easily once the exhaust system is off the car.

Put a jack or axel stand under the exhaust so it doesn't fall on your face.

Remove the three exhaust hanger rubbers - two 13mm AF nuts on each

The exhaust and cat should now be free.

seperate the cat and silencer

If you bought new 10mm bolts you can press out the studs from the ends of the cat using a heavy vice and an old socket.

copper grease everything liberally before putting it back together.

S2

MORE INFO TO BE ADDED SOON - Colbot51

Step 1: Remove the Rear Undertray