Fibreglass repair
Fiberglass repair
Elise and Exige clams are made of glass fiber and XXX resin. Lotus have used two methods, in the S1 and s2 Exige the glass fiber is hand laid and in the S2 elise they have employed a system that injects polyester resin and glass fiber into a mould and the sections are then assembled at Hethel. The hand layed clams are slightly thicker, heavier but stronger than the clams the use the injected method.
Gelcoat
XXX unsure on repair implication
Saftey
When working with glass fiber its is best to use a dust mask and eye protection, whilst preparing the area for repair and working with the material. (due to the possible long term health effects of fiber inhalation)
The glass fibers and resins come together to form a strong, light compersite material.
Glass fiber
comes in several forms which are used for different purposes:
Tissue
Clopped strand matting
Woven
Resins
several resin bases are used
polyesters
epoxy higher toughness than polyester
additional reinforcement
aluminum mesh
Repair thickness
Masking off the undamaged area
mask off using plastic bin bags secured to the body with masking tape. Mask off an area much larger than you think, resin is very messy and if it gets on the paint it will cause damage.
Surface preperation
The first step it to try and maximise the access to the site you are attempting to repair. Some repairs can only be performed with the clam removed. removing clams link
The area that has been damaged may extend further than the surface damage would suggest. The area around the damage needs to be removed. The fastest way is to use an electric grinding tool such as a dremmel so carefully file back the broken fiber glass. A shallow wedged edge should be created around the damage to give a larger surface for the repair to bond to.
chemicals acetone
Working in confined areas such inside the boot can be alkward. One method to make life easier is to prepare the fiberglass and resin on top of a sandwich bag on a flat surface and then use it like a glove to transfer apply the fiberglass and then to smooth it into position.
Finishing
A walk through of a repair
The First step is being able to get behind the damaged area (if possible).
Then Drill out the end of each crack to stop it propagating
(It is still debated if this needs to be done or not)
Please Add Info
Then use a dremmel to remove all the badly damaged and 'powdered' fibreglass, and to 'V' out the track of each crack from the outside.
Then with the dremmel again rub down a few inches around the inside of the cracks.
Now use yourpolyester resin and chopped strand mat and repair on the inside.
Then with the inside repair done start on the outside. Building up layers of CSM matting wherever possible, and fibreglass tissue everywhere else, get a couple of layers into all the 'V' shaped channels you dremmeled earlier.
Now come’s a lot of sanding to bring it all down so there were no bits of resin left proud.
Leave the final filling with putty and sanding to the body shop
See Also
http://forums.seloc.org/viewthread.php?tid=114868
http://forums.seloc.org/viewthread.php?tid=102885