Sports CAT

From TechWiki
Revision as of 11:55, 10 August 2006 by cocjh1 (talk | contribs)
Jump to navigation Jump to search

A Sports CAT allow the engine to breath a little more freely than the standard CAT and should not be confused with a CRP or SCRP.

Standard CATs are ceramic, a Sports CAT tend to be made from stainless steel and therefore can stand more abose without failing. Inside a CAT is a honeycombe type structure which is measured in cells/inch. The heigher the number the smaller the holes and the more restrictive the CAT. Standard CATs tend to be around 400 whereas Sports CATs are anything from 100 to 200.

Noise

Small increase in noise and a few nice pops and bangs.

Performance

A small increase in performance but almost negligible.

Weight Saving

A Sports CAT is considerably lighter than a standard CAT.

MOT & Legality & Insurance

Some are cheap and have a very low 'dose' of wash coat (like 5gramms per cubic foot) - the coatings cost the money, and you can't see them, so it's easy to make savings here.

Then there are different coatings, stuff like MEX45 or MEGC62 etc.

That said, at the end of the day, the higher the surface area, the better it will work as a CAT, this is against the lower flow that a high surface area CAT will have.

For MOT here, a decent (not cheap) 100 cell one will do the job (assuming the engines OK), the only problem comes if you have to pass something like the IM240 test, in which case, you need something dencer than 100Cell.