Difference between revisions of "2-Pot AP Racing Caliper"
Jump to navigation
Jump to search
(Created page with " Torque specs and bolt info for the cross-caliper bolts that hold the 2 halves together: Elise 2-pot caliper Part # CP5119 type M10x1.50 pitch x 55mm long (x2) & M10x1.50 pi...") |
m (Note the threaded length of the bolts and that it follows the standard) |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 3: | Line 3: | ||
Elise 2-pot caliper | Elise 2-pot caliper | ||
| − | Part # CP5119 type | + | Part # '''CP5119''' type |
| − | M10x1.50 pitch x 55mm long (x2) | + | Bolts |
| − | + | *M10x1.50 pitch x 55mm long (x2) | |
| − | M10x1.50 pitch x 70mm long (x2) | + | *M10x1.50 pitch x 70mm long (x2) |
| − | Bridge bolt torque = 58Nm | + | Bridge bolt torque = '''58Nm''' |
| + | ('''NOTE!''' THIS IS FOR THE CROSS-BOLTS, '''NOT''' THE caliper-to-upright bolts! Those are 45Nm) | ||
| − | Bolts need to be correct length of thread and plain shank, in Cap head, Hi tensile grade 12.9. | + | Bolts need to be correct length of thread (32mm for both, following DIN 912) and plain shank, in Cap head, '''Hi tensile grade 12.9.''' |
| − | Information obtained from AP Racing by | + | Information obtained from AP Racing by [https://forums.seloc.org/member.php?action=viewpro&member=steve+111s Steve 111s] on SELOC. Thread [https://forums.seloc.org/viewthread.php?tid=467084&page=1#pid8193519 HERE] |
[[Category:Brakes]] | [[Category:Brakes]] | ||
| Line 19: | Line 20: | ||
[[Category:S1]] | [[Category:S1]] | ||
[[Category:S2]] | [[Category:S2]] | ||
| + | |||
| + | Caliper CP6126 | ||
| + | Correct AP seal kit is CP4518-L | ||
Latest revision as of 20:46, 6 November 2023
Torque specs and bolt info for the cross-caliper bolts that hold the 2 halves together:
Elise 2-pot caliper Part # CP5119 type
Bolts
- M10x1.50 pitch x 55mm long (x2)
- M10x1.50 pitch x 70mm long (x2)
Bridge bolt torque = 58Nm (NOTE! THIS IS FOR THE CROSS-BOLTS, NOT THE caliper-to-upright bolts! Those are 45Nm)
Bolts need to be correct length of thread (32mm for both, following DIN 912) and plain shank, in Cap head, Hi tensile grade 12.9.
Information obtained from AP Racing by Steve 111s on SELOC. Thread HERE
Caliper CP6126 Correct AP seal kit is CP4518-L