Bleed the cooling system
There are two bleed screws on the Elise cooling system. One is on the front left side on the hose that exits the radiator. You may be able to reach it from above by shoving your hand down next to the radiator shroud. Otherwise turn the wheel on full right-hand lock and you should find it behind the wheelarch liner. If not remove the road wheel and you'll see it no problem.
The other is in the engine bay on the metal pipe that runs across the top of the gearbox. (8mm)
The best way to bleed the system is to remove the expansion tank cap and allow the car to idle until it reaches 60C or so. Then increase the revs to around 2000/2500rpm. Once the return pipe is hot in the engine bay (the one with the bleed screw) and the radiator is hot all over the thermostat has opened and you can bleed the system.
Be very careful not to lose the bleed screws or any washers on them. And be very careful of the hot coolant. I find two or three pairs of latex gloves insulate enough to prevent burning.
Handy hint - on an S2, the front bleed screw can be best turned by using a 10p coin in the slot of the screw head. Much easier than trying to turn it by the knurling on the edge and much much easier than getting a screwdriver in there. The S1 was just a thumbscrew. Take care not to over-tighten this screw as well.
Note for LHD cars: the front bleed screw is located on the right side, best accessed through the right wheelarch (At least on mine - LHD S2 K series)
Front Bleed screw located on the DRIVERS side you can remove the wheel arch liner (front section) to feel for the bleed screw.