How to change a fuel filter

S1

1. Jack the left side of the car up quite high and remove the rear wheel. Remove the arch lining.

2. you will now have the whole filter assembly in front of you with plenty of space for tools and any problems. The fuel in the tank will also have gone to the other end of the tank

3. Leave the ignition off for a few hours so most of the residual fuel pressure reduces. Sqiurt both inlet and outlet (upper) with penetrating oil.

4. Have a small container ready and some rags, then remove the lower connecter and pop the loose fuel line into the container, a small amount of fuel will leak out of the filter as well. NOTE: You may find the lower connection is corroded and cannot be undone. if so drop me a U2U I have made stainless adapter for this problem as the original supply line is only available with a new pump!

5. Remove the top connecter and push the filter up and out of the holder.

6. Clean up any mess and fit the new filter, lower the car a little so the fuel is back over the pump and turn the ignition on for 5 seconds then wait 10 seconds, repeat.

7. Start the engine and check for leaks, if all is OK refit arch and wheel.

Check for leaks for a few days afterwards.