Search results

• Drag
  [http://en.wikipedia.org/wiki/Fluid_dynamics Wikipedia On Fluid Dynamics]
  4 KB (699 words) - 10:52, 2 March 2007
• Oil Labelling Explained
  ...low through a standard orifice. The higher the value, the more viscous the fluid. [[Category:Fluid]]
  16 KB (2,734 words) - 15:29, 23 January 2008
• Gearbox oil
  [[Category:Fluid]]
  2 KB (359 words) - 21:19, 3 March 2022
• Servicing
  | Check brake fluid level | Renew brake/clutch fluid
  21 KB (2,747 words) - 18:34, 30 November 2018
• Organic Acid Technology
  [[Category:Fluid]]
  4 KB (634 words) - 00:47, 1 September 2009
• Oil advice
  [[Category:Fluid]]
  4 KB (718 words) - 13:15, 8 July 2009
• Oil and filter change
  ...es) socket/spanner and drain oil into something that will hold 5 litres of fluid. [[Category:Fluid]]
  5 KB (906 words) - 17:29, 19 June 2019
• Brembo Caliper
  ...n a 6-ball caged bearing. All of these parts are internal, bathed in brake fluid, and held captive by a snap ring in the piston and another deep in the cast ...me sticking when water inevitably sneaks into the system. Flush your brake fluid regularly.
  7 KB (1,178 words) - 19:17, 13 October 2023
• Fit a PRRT
  *8 lt of coolant fluid (I used a red OAT product, as recommended by the manifacturer)
  6 KB (972 words) - 14:01, 28 August 2007
• Boot Release Cable
  ...diameter of the new cable. I used some tubing from an Eezibleed Kit (Brake fluid bleed kit)
  4 KB (697 words) - 23:05, 4 November 2018
• Heater Actuator Replacement
  Image:Car void of heater unit.jpg|Note the small amount of coolant fluid loss and plastic bags blocking the pipes!
  3 KB (578 words) - 10:23, 15 June 2016
• Idle Air Control Valve
  ...hose. Cleaned with copious amounts of carburettor cleaner spray (until the fluid runs clear). Fitting is reverse of removal, use silicon grease on the seal
  4 KB (600 words) - 19:54, 20 September 2016
• Evora model history milestones
  ...d pedal box and clutch master cylinder (all models). Clutch line damper in fluid line, inertia weights fitted to gearbox crank lever selector, new low loss ''Transmission:'' 6 speed U660E conventional fluid filled automatic transmission and torque converter assembly electronically
  15 KB (2,201 words) - 14:01, 18 March 2019
• Winter storage
  Check fluid levels such as the engine coolant and oil. It may also be worth doing a qui
  7 KB (1,198 words) - 23:02, 8 January 2013
• Radiator
  ...prudent to have a petrochemical test (sniff test) performed on the coolant fluid if the radiator fails to rule out possible HGF.
  7 KB (1,029 words) - 23:11, 5 February 2017
• How to Rebuild a Brembo Caliper
  ...w is in tight because the tapered end acts as a fluid seal; there is brake fluid on the opposite side. Once it breaks loose, it may not be that difficult t
  11 KB (2,024 words) - 13:10, 11 February 2020
• How to fit a concentric clutch cylinder to the Lotus/Rover Powertrain PG1 gearbox
  The brake/clutch fluid activating the clutch cylinder will have to be routed through the clutch ho
  6 KB (970 words) - 15:47, 5 August 2022
• Windscreen wipers
  ...uires the S2 wiper arm. Extremely good, and very easy to attach the washer fluid bottle to the blade instead of the jets (you'll need about 1 m of 3 mm inne
  5 KB (961 words) - 20:05, 28 April 2015
• Heater Matrix
  [[Category:Fluid]]
  9 KB (1,531 words) - 13:51, 25 May 2023
• Exige V6 model history milestones
  ...A thermostat assembly is fitted in-line within the transmission to cooler fluid feed circuit and is positioned in the LH bodyside wheelarch panel.<br /><br
  23 KB (3,554 words) - 14:05, 18 March 2019

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)