Editing Throttle body (section)

===48MM Body===

The 48mm Throttle body came standard and can be modified to flow alot better (almost as good as the 52mm) by removing the rubber wedge that is located on the throttle body butterfly 

(marked in red on picture below).

[[image:48wedge.JPG|thumb|left|48MM Throttle Body Rubber Wedge]]
{{clr}}

Remove Butterfly from the throttle body and take off the rubber wedge then Heat the butterfly up and put it on a ceramic tile, any metal surface may cause the solder to adhere. Use multi core solder and just push the end into the hole so it contacts the parent metal, it should then melt and brim the hole, if it doesn't the butterfly isnt hot enough.

Key the hole and just outside with P180 wet/dry or similar, or a small file.

[[image:48nowedge.JPG|thumb|left|48MM Throttle Body with removed wedge]]
{{clr}}
[[image:48wedge2.JPG|thumb|left|48MM Throttle Body with removed wedge]]
{{clr}}

Thanks too SELOC member [http://forums.seloc.org/member.php?action=viewpro&member=chrissmith2097 Chrissmith2097] and [http://forums.seloc.org/member.php?action=viewpro&member=DVAndrews Dave Andrews] of DVAPower

See thread http://forums.seloc.org/viewthread.php?tid=107568 for more information.