Difference between revisions of "Replace the horn"
Jump to navigation
Jump to search
m |
m |
||
| Line 18: | Line 18: | ||
[[image:Stockhorn.JPG|thumb|left|The old horn]] | [[image:Stockhorn.JPG|thumb|left|The old horn]] | ||
| + | {{clr}} | ||
| + | |||
| + | [[image:airhorn.JPG|thumb|left|New Horn]] | ||
{{clr}} | {{clr}} | ||
Revision as of 19:32, 4 February 2007
S2 Horn
- Jack up and secure car.
- Remove Drivers side wheel.
- Remove the right access pannel, and fuse cover and remove horn fuse (7.5AMP)
- Remove mudflap screws and pull mudflaps away to gain access to the old horn, there is a 8mm nut and two wires that you need to disconnect.
- Attach the new horn in place of the old horn.
- You may need to drill a hole in the side, but there are lots there already, to make use of.
- A Top Tip is put the tubing in hot water to help it fit over the connectors of the unit and horn ends.
- Once new horn is fitted, fit a new 25AMP fuse inplace of the old 7.5AMP fuse you took out at the begining.
- Test horn, Jobs a carrot