Difference between revisions of "Remove the wheels"

Revision as of 13:30, 22 March 2007

Loosen the 4 wheel bolts with bolt tools found in the Tool roll then jack up the car, then undo the wheel bolts and remove the wheel.

Refit the wheel, replace the 4 wheel bolts so they are hand tight then lower car to the ground and torque wheel bolts to

105NM (S2)

80-85NM (S1)

Check that there is no side to side play by trying to rock the wheel at a quarter to three.

Depress brake pedal a few times to get the pressure back.

Do not over torque the nuts they will shear invest in a torque wrench or you will end up paying out for a new set of wheel bolts.

The S2 wheel bolts are:

M12x1.5 bolt with a tapered seat. (eg. Vauxhall Corsa)

The length should be 25-30mm

Revision as of 13:29, 22 March 2007 (view source) Mr Wiki (talk \| contribs) (→‎Fitting) ← Older edit		Revision as of 13:30, 22 March 2007 (view source) Mr Wiki (talk \| contribs) m Newer edit →
Line 17:		Line 17:


−	[[Image:36_Torque_Wheel_Bolts.JPG]]	+	[[Image:36_Torque_Wheel_Bolts.JPG\|thumb\|left]]
	{{clr}}		{{clr}}