Difference between revisions of "Remove the wheels"
Jump to navigation
Jump to search
m |
m (→Fitting) |
||
| Line 6: | Line 6: | ||
=== Fitting === | === Fitting === | ||
| − | + | Refit the wheel, replace the 4 wheel bolts so they are hand tight then lower car to the ground and torque wheel bolts to 105NM (S2) 80-85NM (S1). | |
Check that there is no side to side play by trying to rock the wheel at a quarter to three. | Check that there is no side to side play by trying to rock the wheel at a quarter to three. | ||
Revision as of 13:29, 22 March 2007
Removal
Loosen the 4 wheel bolts with bolt tools found in the Tool roll then jack up the car, then undo the wheel bolts and remove the wheel.
Fitting
Refit the wheel, replace the 4 wheel bolts so they are hand tight then lower car to the ground and torque wheel bolts to 105NM (S2) 80-85NM (S1).
Check that there is no side to side play by trying to rock the wheel at a quarter to three.
Depress brake pedal a few times to get the pressure back.
Warning
Do not over torque the nuts they will shear invest in a torque wrench or you will end up paying out for a new set of wheel bolts.
Wheel Bolts
The S2 wheel bolts are:
M12x1.5 bolt with a tapered seat. (eg. Vauxhall Corsa)
The length should be 25-30mm