Difference between revisions of "Remove the wheels"
Jump to navigation
Jump to search
m (→S2) |
m |
||
| Line 28: | Line 28: | ||
[[Image:brokenbolt.JPG|thumb|left]] | [[Image:brokenbolt.JPG|thumb|left]] | ||
{{clr}} | {{clr}} | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Revision as of 12:04, 2 July 2007
| Time & Tools | |
| Time: | 30 mins |
|---|---|
| Tools: | Tool roll, Jack, 17mm socket, Wheel brace/extension bar, Copper grease |
Removal
Loosen the 4 wheel bolts with bolt tools found in the Tool roll then jack up the car, then undo the wheel bolts and remove the wheel.
Fitting
Refit the wheel, replace the 4 wheel bolts so they are hand tight then lower car to the ground and torque wheel bolts to
105NM (S2)
80-85NM (S1)
Check that there is no side to side play by trying to rock the wheel at a quarter to three.
Depress brake pedal a few times to get the pressure back.
Warning
Do not over torque the nuts they will shear invest in a torque wrench or you will end up paying out for a new set of wheel bolts.
