Difference between revisions of "Harness bar"
| Line 14: | Line 14: | ||
Sinclaire's harness bar fits to top set belt anchor bolts. | Sinclaire's harness bar fits to top set belt anchor bolts. | ||
| + | |||
| + | == Elise S1 and VX220 Plug and Play, Elise S2 require cutting == | ||
| + | === www.elise-shop.com === | ||
| + | [http://www.elise-shop.com/index.php?main_page=index&cPath=5 www.Elise-Shop.com] | ||
| + | |||
| + | The Elise S1 and VX220 harness bars will fit in the car without any cutting. These harness bars do require the seats to be taken out at installation. | ||
| + | The Elise S1 harness bar is mounted on the original (welded) nuts on the backside of the roll-over hoop. This means the harness bar will be fully supported by the roll-over hoop at an impact. | ||
| + | |||
| + | The Elise S2 harness bar is mounted in the same way and therefore require some cutting of the plastic part behind the seats. The cuts to be made are the size of the harness bar diameter. If cut carefully and kept aside, the bits that came out can be welded back in using thinner. | ||
| + | |||
| + | |||
Revision as of 12:27, 23 July 2007
A harness bar is required to fit behind the seats of the Elise, and secured to the rollover bar, before harnesses can be fitted.
There are various manufactourers of harness bars but they fall into two main categories. Those that require the plastic trim behind the seats to be partially cut and those that don't. There are also various bolt patterns which should be chosen depending upon what type of seat you have.
Require cutting
Spyder
Spyder made harness bars for both the S1 and S2.
Plug and play
Sinclaire
aparrently sell a harness bar that can be fitted without the cutting of the plastic trim.
Sinclaire's harness bar fits to top set belt anchor bolts.
Elise S1 and VX220 Plug and Play, Elise S2 require cutting
www.elise-shop.com
The Elise S1 and VX220 harness bars will fit in the car without any cutting. These harness bars do require the seats to be taken out at installation. The Elise S1 harness bar is mounted on the original (welded) nuts on the backside of the roll-over hoop. This means the harness bar will be fully supported by the roll-over hoop at an impact.
The Elise S2 harness bar is mounted in the same way and therefore require some cutting of the plastic part behind the seats. The cuts to be made are the size of the harness bar diameter. If cut carefully and kept aside, the bits that came out can be welded back in using thinner.
PLEASE ADD INFO