Difference between revisions of "Heater Actuator Replacement"
| Line 3: | Line 3: | ||
MY?? onwards has electronic controlled temperature adjustment which is prone to failure. | MY?? onwards has electronic controlled temperature adjustment which is prone to failure. | ||
| + | <gallery> | ||
| + | Image:Diagram low level heater unit.jpg | ||
| + | Image:Diagram distribution unit.jpg | ||
| + | </gallery> | ||
== Procedure == | == Procedure == | ||
Revision as of 18:32, 1 December 2008
Elise S2 to VIN ????? have manual temperature control.
MY?? onwards has electronic controlled temperature adjustment which is prone to failure.
Procedure
2. Remove both rain water guards
Not sure what their proper name is but the two curved plastic things. The left side one is shown in this photo.
3. Remove rain water guard over wiper motor
4. Remove large air pipe The large diameter air pipe which goes from the heater unit to the distribution unit is not secured in place. It is a simple puch fit.
The large diameter air pipe can be seen centre picture here
5. Move wiring out of way Before the heater unit can be removed the wiring loom needs to be temporary relocated out the way. Snip the cable ties and drag towards the front of the car out the way. Also unplug the wire going into the actuator and blower fan and drag out the way.
6. Separate heater unit from blower fan The heater unit is attached to the fan with two hand clasps. Undo these and forcibly seperate the heater unit from the fan. There is matted material on the front of the heater unit which over time bonds itself to the fan. Simply force these two units apart and take care not to damage the matted material too much!
7. Remove securing bar Remove the securing bar across the top of the heater unit. To 8mm bolts.
8. Remove coolant pipes from heater unit Remove the two coolant pipes going into the heater unit. It's easier to remove these at the car rail pipe end and not on the unit itself. Also provides better access to remove the unit. A small amount of coolant will be lost and the car rail pipes can be blocked up with plastic shopping bags.
9. Remove the heater unit Now the hard part! Shove the fan as far right as it will possibly go and then some more! Lift the front of the heater unit upwards and then diagonally towards the wiper motor. The heater unit will be exiting on the right side of the car.
Note the small amount of coolant fluid loss and plastic bags blocking the pipes!
Heater unit removed and turned through 180 degs to show actuator on reverse side.
10. Clean heater unit
11. Replace actuator
