Replace the horn

S2 Horn

• Jack up and secure car.

• Remove Drivers side wheel.

• Remove the right access pannel, and fuse cover and remove horn fuse (7.5AMP)

• Remove mudflap screws and pull mudflaps away to gain access to the old horn, there is a 8mm nut and two wires that you need to disconnect.

• Attach the new horn in place of the old horn

• You may need to drill a hole in the side, but there are lots there already, to make use of.

• A top tip is put the tubing in hot water to help it fit on the connectors of the unit and horn ends.

• Once new horn is fitted, fit a new 25AMP fuse inplace of the old 7.5AMP fuse you took out at the begining.