Search results

Jump to navigation Jump to search

Page title matches

  • Bleed the brakes
    ...t to refresh the brake fluid, you can either connect a pressure bleeder or bleed manually. ...ith brake fluid, connect to reservoir, pressurise bleeder. One by one open bleed valves on calipers until fluid runs clear.
    7 KB (1,292 words) - 13:27, 11 June 2022
  • Bleed the cooling system
    [[Image:bleed screw.jpg|thumb|left|Plastic bleed screw]] There are two bleed screws on the Elise cooling system. One is on the front left side on the ho
    3 KB (575 words) - 15:04, 10 June 2014

Page text matches

  • Replace the coolant
    ...ing with suitable [[coolant]], you will need to [[Bleed the cooling system|bleed]] the system.
    505 bytes (77 words) - 11:18, 25 February 2008
  • Coolant system
    Image:rad bleed.JPG|Radiator Bleed Plug
    752 bytes (119 words) - 22:27, 3 June 2008
  • Bleed the cooling system
    [[Image:bleed screw.jpg|thumb|left|Plastic bleed screw]] There are two bleed screws on the Elise cooling system. One is on the front left side on the ho
    3 KB (575 words) - 15:04, 10 June 2014
  • S1 aluminium heater pipe repair
    ...ystem with a suitable coolant and bleed cooling system as described here [[Bleed the cooling system]]
    2 KB (353 words) - 21:47, 2 May 2010
  • Bleed the brakes
    ...t to refresh the brake fluid, you can either connect a pressure bleeder or bleed manually. ...ith brake fluid, connect to reservoir, pressurise bleeder. One by one open bleed valves on calipers until fluid runs clear.
    7 KB (1,292 words) - 13:27, 11 June 2022
  • Replacing S1 front near-side brake pipe
    '''IMPORTANT: Bleed brake system and check brakes working fine'''
    1 KB (197 words) - 19:43, 4 July 2014
  • Brake fluid
    • Remove a front caliper, invert it open the bleed nipple and tape the brake hoses gently and also tap on the inside of the ca ...eeze the OUTER piston back into the caliper. Once it's fully in, close the bleed nipple and do the other side.
    6 KB (1,037 words) - 20:04, 9 May 2016
  • How to fit a concentric clutch cylinder to the Lotus/Rover Powertrain PG1 gearbox
    ...g the clutch cylinder will have to be routed through the clutch housing. A bleed line pass-through should also be provided for. ...rilling, cut a M6 thread in place and thereby establish a connection for a bleed line.
    6 KB (970 words) - 15:47, 5 August 2022
  • Replacing S1 rear brake pipes
    '''IMPORTANT : Bleed brake system and check brakes working fine'''
    2 KB (329 words) - 21:07, 20 February 2019
  • Replace the radiator & cooling fans
    ...e: Replace the radiator step 2a.jpg|Looking down onto the inlet pipe where bleed screw is located (MY04 Elise!) ...reverse order to removal and [[Replace the coolant|refill with coolant and bleed]]'''
    6 KB (1,048 words) - 21:33, 22 April 2020
  • Clutch
    ...that the pushrod is cable tied all the way back into the cylinder and then bleed the system.
    3 KB (521 words) - 15:15, 12 November 2019
  • Fit a PRRT
    ...ed. Refill the circuit with coolant, check all the junctions for leaks and bleed the system as on the Service Manual.
    6 KB (972 words) - 14:01, 28 August 2007
  • Boot Release Cable
    ...er of the new cable. I used some tubing from an Eezibleed Kit (Brake fluid bleed kit)
    4 KB (697 words) - 23:05, 4 November 2018
  • Heater Matrix
    ...the plastic radiator cowl just yet as it is easier to get to the radiator bleed screw when bleeding the system. If any of the plastic fasteners were broken ...lly add coolant back into the header tank and follow the instructions in [[Bleed the cooling system]].
    9 KB (1,531 words) - 13:51, 25 May 2023
  • Brembo Caliper
    ...also available (part number?) and complete kits that include everything. Bleed nipples are 10mm and common with most Ford calipers (available from most mo
    7 KB (1,178 words) - 19:17, 13 October 2023
  • Charge cooler install
    33. Follow the procedure to bleed the main radiator(https://wiki.seloc.org/a/Bleed_the_cooling_system), keep 33b. Bleed the CC system by just running it for a bit (either with engine running or j
    16 KB (3,021 words) - 15:22, 11 February 2020
  • S2 Track Modifications
    ...need fresh fluid (Castrol Super DOT4 £10, AP600 £20, SRF £50) and plan to bleed fluid regularly (every 2 to 6 track hours) plus completely change it annual
    11 KB (1,955 words) - 21:22, 28 February 2008
  • Servicing costs
    All prices include Parts,Labour & VAT, and include a brake/clutch bleed.
    12 KB (1,606 words) - 15:06, 23 April 2019
  • Cambelt
    40. Lower the car and bleed the cooling system per the service manual or
    15 KB (2,706 words) - 20:36, 21 August 2023

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)

Retrieved from ‘https://wiki.seloc.org/a/Special:Search’