Search results

Jump to navigation Jump to search
  • ===S2 (K-series)=== ...merald (the ECU can't drive it). If you require the IACV then you'll need one from an S1, these are available from Eliseparts.
    658 bytes (110 words) - 14:08, 17 October 2014
  • There are two bleed screws on the Elise cooling system. One is on the front left side on the hose that exits the radiator. You may be a ...to around 2000/2500rpm. Once the return pipe is hot in the engine bay (the one with the bleed screw) and the radiator is hot all over the [[thermostat]] h
    3 KB (575 words) - 15:04, 10 June 2014
  • ==Episode I - The K-Series Menace== ...nt conflict brews between Simon Scuffham and his powerful but unreliable K-Series engine. He travels to Scholar to warn them of the fallout which is to follo
    5 KB (885 words) - 17:41, 13 December 2015
  • ==ZZ-series Gearboxes== Gearboxes used in cars equipped with ZZ-series engines, such as the 111R, Toyota engined "Elise S", S2 Exiges and the 2-El
    5 KB (667 words) - 21:59, 8 July 2021
  • - '''Nitron Street Series (NSS)''' - a basic and non-rebuildable, road biased addition to Nitron's ra ...mper for use on a Series 1 would have different setup to one for a heavier Series 2 car.
    7 KB (1,179 words) - 09:28, 23 August 2015
  • 1.Remove the one screw holding the black phone/cup holder between the back of the seats. Rem ...his easily. Now you can remove this part, the second. All of the plugs are one way, no need to write anything down or remember wire colours or whatever, n
    4 KB (674 words) - 08:48, 3 January 2014
  • ...lower the freezing point when mixed in to water. Almost all coolants use one or more of three chemicals to provide the antifreeze effect: ...nts all have much the same antifreeze regardless of anything else. Choose one with glycerol if you really want to be eco, although it will still be mostl
    8 KB (1,265 words) - 17:03, 6 April 2022
  • ...rse mid-mounted, water-cooled all-alloy double overhead-cam 1796cc Rover K-series in-line four with four valves per cylinder and MEMS muli-point fuel injecti First: 3.17to one.
    10 KB (1,477 words) - 15:01, 31 March 2019
  • | K series (S1) - 118hp | K series - 118hp
    5 KB (942 words) - 21:04, 30 August 2015
  • ===K series Elise=== "The Torque curve increased by 4 Ft Lbs Average and at one point on the curve an 11 Ft Lbs increase was recorded. This 11 Lbs increase
    2 KB (421 words) - 11:41, 10 October 2019
  • ...A TPS may fail gradually leading to a number of symptoms which can include one or more of the following: - ...on the dashboard. Extreme cases can cause excessing misfires resulting in one or more cylinders being shut down to prevent engine and catalytic converter
    4 KB (685 words) - 16:02, 13 August 2013
  • ===HANGAR 111 Signature Series=== Four into One Exhaust Collector - Stainless Steel £242.26 plus VAT
    12 KB (1,543 words) - 09:27, 11 October 2018
  • ...ed an AEG torque application device for this step. You can see me removing one of the screws with the AEG on the left hand side. ...d to disconnect the throttle cable side first so a Phillips screwdriver on one side and a 7mm socket on the other.|left]]
    8 KB (1,434 words) - 18:01, 19 March 2020
  • ...the service life of these supposedly maintenance-free batteries, although one should be careful not to over dilute the electrolyte level. ...y, adjusting the charge given to the battery as necessary. The Accumate is one such charger, although there are others that should be suitable.
    10 KB (1,655 words) - 16:03, 9 October 2018
  • ...dure for changing rear pads on an S1 Elise. (Its the same caliper on the K series S2 models and most likely still in use on the Tonka Toy engined cars) ...ing pin towards the outside. The hole is much smaller at the back than the one you see at the front
    5 KB (861 words) - 21:23, 18 January 2019
  • '''Never replace a fuse with one of bigger amperage. This could damage the device the fuse is meant to prote ...ic cover. Twenty two slots are provided for standard size 'Littelfuse' 257 series blade fuses which are numbered, and [[Fusebox#Fuse Colours|coloured]] accor
    16 KB (2,482 words) - 13:02, 5 February 2023
  • ...'''PRRT''' is actually a misnomer (albeit harmless), allegedly invented by one of the members of the Seloc forum. The PRRT acronym may not actually be rec ...) with this one if they have to open the coolant circuit. '''''THIS IS THE ONE YOU WANT !!!'''''
    8 KB (1,252 words) - 13:49, 27 April 2018
  • One of the benefits of Adherent Friction is that under normal use the discs las ...ige and 340R, were fitted with the same cross drilled disks as seen on the Series 1 111s and Sport 160 editions described above.
    14 KB (2,435 words) - 16:46, 7 May 2022
  • The Elise manual says 26F/27.5R for Bridgestones on a K series but this may be too high with rear centre tread wearing first. | '''Elise S2 K series'''||'''FRONT'''||'''REAR'''||'''Road or Track?'''||'''Used by'''
    8 KB (1,241 words) - 16:23, 23 August 2021
  • ...nd the chassis (a 6 sided socket is stronger than a 12sided. Silverline do one for a couple of ££'s from Amazon) . A Rover K Series camshaft locking tool
    15 KB (2,706 words) - 20:36, 21 August 2023

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)