Search results

Jump to navigation Jump to search
  • {| border="1" {| border="1"
    4 KB (368 words) - 12:33, 3 August 2022
  • ...ch turn is around 1.7mm and you need to use a magnifiction ratio of around 1.6 due to tyre and damper angle so each turn of the upper spring seat should {| border="1"
    3 KB (353 words) - 11:05, 28 July 2016
  • {| border="1" {| border="1"
    9 KB (876 words) - 12:33, 3 August 2022
  • | 1-way (Combined bump and rebound) | £1,410
    9 KB (1,413 words) - 00:27, 23 December 2017
  • 1. Using a 2.5mm allen key, remove the grub screw on the front side (the side 1. Cut a piece of wet and dry 600 3 inches width of the sheet.
    2 KB (344 words) - 12:25, 21 October 2016
  • The Rover S2 uses 3 identical bearing packs without built-in sensor and 1 pack with a sensor for the ECU (which then relays it to the speedo) on one
    1 KB (199 words) - 20:18, 9 June 2011
  • ...owered S2 (111R, Fed-Elise, Exige2) also connects the CAN bus (running at 1 megabit/s) to the dash unit and does away with most of the discrete inputs 1 = Enhanced (manufacturer specific)
    4 KB (667 words) - 10:45, 5 January 2018
  • {| border=1 cellpadding=5 cellspacing=2 ...tandard manifold 3.3kg flexi pipe 3.4kg || k series full stainless steel 4-1 manifold 8kg
    7 KB (1,029 words) - 23:05, 30 August 2019
  • ==== Child Seats Group 1 (9 months - 4 years) ==== *Britax Evolva123 (Groups 1,2&3)- suitable for the rear seats in the Evora (Base too wide for standard
    4 KB (673 words) - 21:44, 14 August 2022
  • {| border="1"
    1 KB (249 words) - 12:43, 25 July 2011
  • {| border="1" | 1 - 100
    5 KB (784 words) - 15:06, 7 January 2022
  • {| border="1" {| border="1"
    4 KB (659 words) - 15:56, 21 July 2022
  • {| border="1" {| border="1"
    12 KB (1,606 words) - 15:06, 23 April 2019
  • {| border=1 cellpadding=5 cellspacing=0 ! Gearbox Code !! 1 !! 2 !! 3 !! 4 !! 5 !! Final Drive !! Used In
    4 KB (491 words) - 10:24, 22 November 2021
  • 1 x Catalyst hanger bracket (Lotus part A111G6001F) ( 3 rubber mounts are used, 2 on the 'back box' and 1 one the CAT).
    5 KB (827 words) - 15:54, 22 November 2019
  • {| cellpadding="8" cellspacing="0" border="1"
    2 KB (293 words) - 15:38, 10 March 2013
  • ..., as fitted to the Toyota Auris 2.0 D-4D and 2.2 D-CAT models.<sup>[[#ref1|1]]</sup> These are diesel engines, and the standard ratios are as they in th {| border=1 cellpadding=5 cellspacing=0
    7 KB (1,123 words) - 21:54, 8 July 2021
  • {| border="1" | Unit 1,Naylor Court,Blaydon,Tyne & Wear, [http://maps.google.co.uk/?hl=en&q=NE21+5
    9 KB (1,428 words) - 12:33, 11 January 2024
  • {| border="1"
    1 KB (199 words) - 17:19, 10 February 2019
  • 1. Wetness of door sill trim 4. 1 per door
    5 KB (834 words) - 11:44, 20 February 2016
  • '''Stage 1 (Removing old paint)'''
    2 KB (386 words) - 14:16, 19 January 2012
  • {{Infobox Timetools | time=1 hour | tools=[[Ball joint splitter]], spanner, jack}} '''1. Raise car and remove front wheels'''
    5 KB (916 words) - 12:34, 30 May 2013
  • - Union 1: BN3 10mm x 1mm standard male
    1 KB (197 words) - 19:43, 4 July 2014
  • {| border="1" | [http://news.seloc.org/1/ October 2004] || 10/2004 || '''Welcome''' - Welcome to the first monthly
    14 KB (2,178 words) - 22:35, 27 August 2011
  • '''Step 1''' - '''DISCONNECT BATTERY FIRST !!!!!'''
    2 KB (327 words) - 00:03, 6 November 2012
  • {| border=1 cellpadding=5 cellspacing=0 | Elise S1 (120bhp) || MEMS 1.9 || proprietary || LotusScan (Connector SAE J1962)<br />or Rover Test-Book
    6 KB (945 words) - 15:04, 13 January 2020
  • 1. An early S2 with H1/H7 headlamp cluster (inside wheel arch liner AND front
    1 KB (195 words) - 22:17, 23 May 2014
  • {|border=1 {|border=1
    7 KB (1,029 words) - 23:11, 5 February 2017
  • Bulbs as fitted as standard to Series 1 Elises/Exiges. <table cellspacing="0" cellpadding="3" border="1">
    5 KB (894 words) - 22:16, 17 February 2023
  • ...you have measured the shaft end play without shim pack. In my case it was 1,68 mm. ...her should be allowed to take up. In my case it summed up to 0,83 + 0,17 = 1,00 mm.
    8 KB (1,467 words) - 20:21, 25 April 2014
  • ...f the injectors. Tell tale signs can include rusty spark plugs on cylinder 1 and 4, sometimes even all four, lumpy idle or misfiring, high emissions, je
    2 KB (230 words) - 19:10, 5 September 2011
  • '''1. [[Remove the headlamp cover]]''' Next up, poke through the rubber grommet from inside (1) and trim the inner edge a little (2) to free things up a little for when i
    6 KB (944 words) - 19:38, 13 February 2015
  • The toe-in of each straight edge can therefore be calculated to: 30/3998=1/133 mm ⁄ mm ...ans that for every mm you go forward along the straight it goes inwards by 1/133 mm.
    5 KB (924 words) - 21:26, 19 April 2020
  • 1. Check that the right-hand most "switch" in your light panel is a dummy. I ...ch was. It will work best if you offset the template to the right by about 1-2mm. Don't go too far though otherwise the switch surround won't go back o
    4 KB (654 words) - 14:03, 18 June 2014
  • 1. Homebase for two bits of 2400mm rigid aluminum (16mm ally channel as they 1. To measure camber I made a plumb line out of stuff lying around (net curta
    6 KB (1,004 words) - 01:13, 6 March 2017
  • [[Image:CDLModuleReplace3.jpg|left|thumb|Move vent hose 1]] [[Image:CDLModuleReplace5.jpg|left|thumb|Module 1]]
    4 KB (742 words) - 13:34, 19 January 2012
  • {| cellpadding="8" cellspacing="0" border="1" |1
    16 KB (2,482 words) - 13:02, 5 February 2023
  • {| border=1 cellpadding=5 align=center ...2 || 130/130mm || +3.8° || -0.1° || 0.2mm OUT Overall [-0.03°] || -1.8° || 1.2mm IN each side [0.16°]
    7 KB (957 words) - 14:44, 4 August 2023
  • {| border="1" {| border="1"
    8 KB (1,241 words) - 16:23, 23 August 2021
  • ...his installation at http://forums.seloc.org/viewthread.php?tid=171330&page=1#pid3347959 1. Mute selecter: Set key hold after power on
    6 KB (1,086 words) - 15:09, 17 March 2012
  • Twin coolers are only fitted as part of the supercharger pack else 1 cooler. - Ads_green Lotus stage 1 exhaust as std, the later cars had a much larger and heavier back box. - Th
    6 KB (1,112 words) - 15:34, 12 December 2011
  • | 1 | 1
    16 KB (2,081 words) - 16:04, 9 August 2022
  • A bit noisy if used with a cat pipe and Janspeed 4-2-1 manifold. It has a nasty resonance at 3,300rpm - and that is 80 mph in an S ====4 into 1====
    12 KB (1,543 words) - 09:27, 11 October 2018
  • * MANN W 67/1
    1 KB (232 words) - 08:50, 24 August 2018
  • *S2 = 1mm (1.00mm) gap The electrode is extremely thin (only approx 1 to 2mm) and can damage easily.
    2 KB (274 words) - 21:31, 5 February 2019
  • ...mber that you need to order is 10501, delivery should be expected in about 1 week. You may also be able to get it from a UK Jeep dealer - please add you [[image:fuel cap 1.jpg|thumb|left]]
    6 KB (1,092 words) - 13:32, 14 August 2015
  • {| cellpadding="8" cellspacing="0" border="1"
    2 KB (338 words) - 22:30, 19 January 2015
  • ===Team Dynamics Pro Race 1.2S=== | price = Retail inc VAT £1,682.60
    14 KB (1,847 words) - 18:10, 7 August 2017
  • ...sm, I got one from Eliseparts.com. You'll also need small Allen keys, 10mm 1/4inch socket, 10mm spanner, medium size posidrive/cross head screwdriver. 1. Remove the door card, this should just be a few Allen heads, velcro, one p
    5 KB (803 words) - 14:11, 3 June 2023
  • [[image:Evora footwell and gearbox tunnel draught - 1.jpg|right|thumb|100px]] '''1.''' Remove the fusebox panel in the passenger footwell and locate the relay
    3 KB (444 words) - 17:37, 22 February 2013

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)